Project Services
Technical Consultancy
Management Consultancy
Software Solutions
Current
UK & Ireland Featured Project: NGN - Design Management

QEM Solutions are assisting NGN with Design Co-ordination activities, to ensure successful project initiation and design management of all current NGN projects.

Tell Me More...
Overseas Featured Project: Capita Symonds - Valve Inspections

QEM Solutions were contracted to carry 3rd party inspection and witnessing activities on a series of valves fabricated in Germany for a series of SGN contracts throughout Scotland.

Tell Me More...
We are QEM Solutions We are QEM Solutions

We are problem solvers. We are organisers. From the project start-up to the very final evaluations and analysis, we can bring enthusiasm to each and every part of your project.

 

About
Current
Archive More...
News Spotlight Too much to ask? Maintaining certification in a pandemic

With profits slashed by lockdown, SMEs are running as lean as possible. In response, many are considering certification lapse until trading gets back to ‘normal’. But is this wise?

Read more...
 
Our projects

Our Projects

Combined, we have over 50 years experience, gained on a variety of projects throughout the world. But no two engineering projects are alike.

Sometimes we manage a project from the very start and continue to be involved until the end reports. Other times we are brought in to provide specialist services in specific areas. Each brings different challenges. Each has different outcomes.

We would like to share just a few of these projects here.

Show map

Our Projects

LPG and Heavy Fuel Oil Generator DSEAR Assessment (1630) Ignition Hazard Assessments (Non Electrical - EN 80079) (DSEAR)

Aggreko


1 Jun 2018 - 1 Sep 2018

QEM Solutions were asked to assist Aggreko  in the development of the type LPG  and Heavy Fuel Oil Generator set with respect to completing a risk assessment to help demonstrate compliance with the Dangerous Substances and Explosive Atmospheres Regulations 2002 (DSEAR).

QEM carried out a full review of the apparatus in accordance with IGEM/SR25 to assess the possible risk in accordance with  DSEAR. This included both desk based and on site validaion of the equipment and operations.

Following the DSEAR risk assessment various points were identified that, if incorporated into the Generator design, will further reduce the risk of fire and/or explosion that is always a potential with hydrocarbon powered equipment.

 

 Services Breakdown

 Engaged Specialists